Fees and charges
Equivalent Full Time Student Load (EFTSL)
EFTSL is the standard annual full time load. Eight credit points is the standard full time load for one year of study.
This is a fee-paying course. Domestic students may be eligible for FEE-HELP assistance in paying these tuition fees. For more information about FEE-HELP go to http://www.deakin.edu.au/future-students/fees/
Fee paying place - Domestic (DFP)
A Fee paying place is one for which the university does not receive any government funding. As such, students enrolled in these places are required to contribute the full cost of their course.
Fee paying places are available to domestic students. Domestic students are those who are Australian citizens, New Zealand citizens or holders of a permanent visa.
* The 'indicative annual course fee' cited has been provided as a guide only. It has been calculated on the basis of a typical enrolment of a student undertaking the course in 2009, and reflects the cost involved in undertaking a full-time quota of units within the specified discipline.
The actual fees charged by Deakin University will depend upon the discipline from which each individual unit is chosen, and may vary from the indicative course fee cited, particularly if units are chosen from a number of disciplines. The cost of each unit offered in 2009 can be viewed at http://www.deakin.edu.au/current-students/handbooks2009/search.php.
Please note that the fees per unit/credit point may increase annually due to rises in the cost of course delivery and service.
Deakin assumes no responsibility for persons relying on 'indicative course fees' to calculate the total future cost of their course.
The course comprises 16 credit points, which can be completed on a full-time basis over four trimesters or part-time equivalent. Applicants must hold an approved undergraduate degree.
Students complete 16 credit points, meeting all requirements for the 12 credit point Master of Information Technology, followed by a further 4 credit points from below:
SIT790 Research Project or
SIT791 Professional Practice or
SIT792 Research Project Part A and
SIT793 Research Project Part B or
4 additional credit points chose from the list of general units in the Master of Information Technology.
Students are encouraged to complete either the internship or research project.
Students must have access to a suitable computer and a network connection. Information about hardware and software requirements may be obtained from the School of Engineering and Information Technology's website www.deakin.edu.au/scitech/eit or by telephone 03 5227 2536.
Admission requirements - general
Deakin University offers admission to postgraduate courses through a number of Admission categories.
In all categories of admission, selection is based primarily on academic merit as indicated by an applicant's previous academic record.
For more information on the Deakin Admissions Policy visit The Guide
Admission requirements - specific
To satisfy the general entrance requirements for admission to the Master of Information Technology(Professional) a student must hold an approved undergraduate degree. Students who hold an undergraduate degree in a non-computing field will be required to take a compulsory core of four foundation units.
Advanced standing - general
The University aims to provide students with as much credit as possible for approved prior study or informal learning which exceeds the normal entrance requirements for the course and is within the constraints of the course regulations. Students are required to complete a minimum of one-third of the course at Deakin University, or four credit points, whichever is the greater. In the case of certificates, including graduate certificates, a minimum of two credit points within the course must be completed at Deakin.
You can also refer to the Advanced Standing System which outlines the credit that may be granted towards a Deakin University degree.
Advanced standing - specific
Advanced standing may be granted to applicants based on prior studies and/or equivalent industry experience.
How to apply
Applications must be made directly to the university through the Applicant Portal referring to closing dates for applications as dates for particular courses may vary.
Your faculty may require further information from you when submitting your application. Please refer to the faculty information website for further details.